The
Manitoban Multi Fuel (MMF) is a Canadian product developed by Tracker
Manufacturing of Manitoba. This product is being produced to fill
the need of many North American customers that are or have expressed
their concerns over the increasing costs of conventional fuels such
as, natural gas, propane, fuel oils and electricity.
The owner of Tracker uses
this product to heat a 60ft x 80ft plant with 14ft ceilings which
is located in Manitoba Canada. Winter temperatures in this region
often drop to - 40 degrees Celcius for weeks at a time combined
with high winds which places an even highier demand on a heating
appliance.Tracker Mfg. felt that the added safety of an outdoor
furnace that would burn alternate fuels of lower costs was needed,
and should be made available at a affordable price.
Thus the
MMF a non pressurized outdoor boiler, designed to burn fuels that
will flow and can be augerred was created. At present, corn test
have shown that fuels need to have a 14% or less moisture content
to maintain ignition in the shut down stages. The MMF has the ability
of control to as little as a 2 degree on-off firing to maintain
fuel glow as well as an automatic shut down in the event of a fuel
or fire out situation. The carburetor has 70 air jets for performance
burning to enhance a complete burn and reduce clinkers. This product
also has a built in 26 bushel hopper, complete with a vari-speed
auger and adjustable air control all mounted in an easily accessible
panel for customer tuning.
An Outdoor Hot Water Furnace that :
BURNS = CORN SUNFLOWER - GRAINS
Technical Specification
HEIGHT - 60"
WIDTH - 48"
LENGTH - 72"
WEIGHT - 1540 lbs.
150 - 250,000 btu's depends on fuel used.
Stainless Steel
Fire Pot
50 US gallon exchanger c/w horizontal
flues
Fuel Drive Unit Included
14 RPM c/w vari speed control
180-1 gear ratio- 340 in/lbs torque 90 volt
Fuel or fire out shut down
Digital Aqua Stat
Settings as fine as 2 degrees on-off
Soft touch user friendly programming (no tools required)
High Profile Cladding
Neutral Dark gray or Melchar green
One piece steel roof
Plumbing Hook Ups
One 1.25" NMPT feed
One 1.25" NMPT return
Foot Base
Allows furnace to be lifted from under unit
Also has top lift eyelet
Forced Air
160 CFM adjustable
Hopper Included
Built in -26 bushel capacity
Bulk feed port for gravity wagon feed (option)
Ash Pan
32" x 32" x 6" MS
Chimney
8" horizontal - rear exhaust
Insulation
6" fiberglass or greater
Inner Panels
14 -16 gauge MS
Slip jointed for expansion
* Specifications are
subject to change without notice. |
